Uniwell NX-5400 User Manual download pdf (Page 6)

II. INSTALLATION

Unpacking

Check the contents for obvious physical damage.

Suggestions for installation

1) The ECR should not be installed in extremely hot or cold places, or places which are exposed to direct sunlight for

extended periods of time.

2) The ECR should not be installed where it may come into contact with excessive dust.

3) The ECR should not come into contact with liquid.

Check the following before using ECR

1) The required peripheral(s) has (have) been connected to the correct interface connector(s);

2) The power plug is connected to the AC outlet;

3) The control key is turned to the appropriate position;

4) The appropriate number of paper roll(s) is (are) fitted.

If EE-99 is displayed

It indicates that ECR data might be collapsed because of a low battery condition by battery discharge while ECR is in stock

for a long period. Perform Physical RAM Test and Auto Preset, then leave ECR ON for minimum of 3 hours for battery

charge. Contact your distributor for the steps.

When you connect / disconnect the cable for the peripheral,

make sure that the AC cord is disconnected.

control lock

rear display

1-line numeric

12 digits

paper window

front display

1-line numeric

12 digits

validation slot

printer cover

1 2 3 4 5 6 7 8 9 10 11 ... 89 90

No comments

Uniwell NX-5400 User Manual Page 6