Uniwell NX-5400 User Manual download pdf (Page 75)

VIII. REPORTS

REPORT SEQUENCE

Set the control key to X, Z1 or Z2 position and use the report sequence below;

- 1st level for daily report : X (read only) position or Z1 (reset) position

- 2nd level for periodic report : X (read only) position or Z2 (reset) position

For Z report issue and report format, there are some programming restrictions. Refer to system function flags [SF-26~29]

and the clerk security function flags.

FULL REPORT

INDIVIDUAL REPORT

PLU report: Scanner can be used for entering the required #.

Clerk report: Enter the sequential clerk number (not secret clerk code).

SEQUENTIAL REPORT

PLU report: Enter PLU codes for the start and end numbers.

Scanner can be used also.

X/Z

Report #

TTL

X/Z

Report #

TTL

Start # X2 End #

for another

X/Z

Report #

TTL

Required #

•

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 89 90

No comments

Uniwell NX-5400 User Manual Page 75